Roland SP-404MK2 - Ring Mod; Crusher; Overdrive; Distortion

Appendix
122
Parameter
Value
Explanation
NOTE
-17– -1, 1–18
Sets which note in the chromatic scale should resonate, counting from the
root of the SCALE value.
SPREAD
UNISON, TINY, SMALL,
MEDIUM, HUGE
Sets the octave of the resonator.
CHARACTER
0–100
Adjusts the brightness and detuning of the sound.
SCALE
C maj–B maj, C min–B min
Sets the composite notes (chord) to resonate.
FEEDBACK
0–99 (%)
Adjusts the amount of feedback for the effect.
ENV MOD
0–100
Larger values increase the amount of feedback according to the input level.
Ring Mod
This effect alters the tonal character to make the sound more metallic.
Parameter
Value
Explanation
FREQUENCY
0–100
Sets the frequency range to which the effect is applied.
SENS
0–100
Adjusts the volume of the effect sound.
BALANCE
100-0–0-100 (%)
Adjusts the volume balance between dry (the original sound) and effect sound.
POLARITY
OFF, ON
Sets the direction in which the frequency modulation moves.
EQ LOW
-15–15 (dB)
Adjusts the amount of boost/cut of the low-frequency range.
EQ HIGH
-15–15 (dB)
Adjusts the amount of boost/cut of the high-frequency range.
Crusher
Produces a lo-fi effect.
Parameter
Value
Explanation
FILTER
331–15392
(Hz)
Sets the frequency range in which the pre-filter (the filter that the sound passes through
before effects are applied) works.
RATE
0–100
Sets the sample rate of the effect. Larger values make the sample rate lower, for a more lo-fi
sound.
BALANCE
100-0–0-100
(%)
Adjusts the volume balance between dry (the original sound) and effect sound.
Overdrive
Mildly distorts the sound.
Parameter
Value
Explanation
DRIVE
0–100
Adjusts the amount of distortion.
TONE
-100–100
Sets the tone. Larger settings emphasize the high-frequency range. Smaller settings
emphasize the low-frequency range.
BALANCE
100-0–0-100
(%)
Adjusts the volume balance between dry (the original sound) and effect sound.
LEVEL
0–100
Adjusts the volume of the effect sound.
Distortion
Intensely distorts the sound.
Parameter
Value
Explanation
DRIVE
0–100
Adjusts the amount of distortion.
TONE
-100–100
Sets the tone. Larger settings emphasize the high-frequency range. Smaller settings
emphasize the low-frequency range.