Appendix
112
BUS 3, BUS 4
EFX TYPE
Bypass, 303 VinylSim, 404 VinylSim, Cassette Sim, Lo-fi, Downer, Compressor,
Equalizer, Isolator, Super Filter, Filter+Drive, WrmSaturator, Overdrive, Distortion,
Crusher, Ring Mod, SBF, Resonator, Hyper-Reso, Chromatic PS, Reverb, Ha-Dou, Zan-
Zou, Sync Delay, TimeCtrlDly, Ko-Da-Ma, Tape Echo, Chorus, JUNO Chorus, Flanger,
Phaser, Wah, Slicer, Tremolo/Pan, To-Gu-Ro, DJFX Looper, Scatter
assigned to BUS 3 or
BUS 4.
For details on the
parameters of each
effect, refer to “MFX
DIRECT
Direct FX1–
Direct FX5
Filter+Drive, Resonator, Sync Delay, Isolator, DJFX Looper, Scatter, Downer, Ha-
Dou, Ko-Da-Ma, Zan-Zou, To-Gu-Ro, SBF, Stopper, Tape Echo, TimeCtrlDly, Super
Filter, WrmSaturator, 303 VinylSim, 404 VinylSim, Cassette Sim, Lo-fi, Reverb,
Chorus, JUNO Chorus, Flanger, Phaser, Wah, Slicer, Tremolo/Pan, Chromatic PS,
Hyper-Reso, Ring Mod, Crusher, Overdrive, Distortion, Equalizer, Compressor
effects you like to the
effect buttons on the
top panel.
For details on the
parameters of each
effect, refer to “MFX
OTHER
Mute Bus
This individually selects the bus to mute with MUTE BUS.
ALL
Both BUS 1 and BUS 2 are
muted.
BUS
Only the bus selected with the
[BUS FX] button is muted.
Input FX
Bypass, Auto Pitch (*), Vocoder (*), Gt Amp Sim (*), Harmony (*), Chorus,
JUNO Chorus, Reverb, TimeCtrlDly, Chromatic PS, Downer, WrmSaturator,
303 VinylSim, 404 VinylSim, Cassette Sim, Lo-fi, Equalizer, Compressor
Effects marked with an (*) are for INPUT FX only.
You can apply effects to the
audio that’s inputted to this unit.
For details on the parameters of
each effect, refer to “MFX
Input Bus
You can set the bus to which the playback audio signals coming into the INPUT jack are sent (meaning which
effects are used).
DRY
The signal is not sent to BUS 1,
BUS 2 (the BUS 1 and BUS 2
BUS1, BUS2
The signal is sent to BUS 1 or
BUS 2. The effects set for BUS 1
This sets the routing for audio sent to the DRY bus.
To Next Page
Loading...
