Roland SP-404MK2 - Pattern Playback in DJ Mode

Mixing the Samples (DJ MODE)
79
Controller
Action
[CTRL 2] knob (when the
loop is on)
Moves the loop point.
[CTRL 3] knob
Moves the end point.
[SHIFT] button + [CTRL]
knob (turn)
Zooms the area around each point in/out.
[VALUE] knob (turn)
Zooms the area in/out around each point you just manipulated.
[VALUE] knob (press)
You can use a numerical value to set the position of each point.
Use the [VALUE] knob to select the point to set, and press pads [1]–[10] to input the
position (press pad [10] to input a “0”).
To confirm the inputted position, press the [VALUE] knob.
[SHIFT] button + [VALUE]
knob (turn)
Adjusts the volume of the channel.
[DEL] button
Initializes the start and end point positions.
● When a confirmation message appears, use the [VALUE] knob to select “OK”, and
press the [VALUE] knob.
[REMAIN] button
On: Prevents the start point from being moved beyond the loop point or the end point.
Off: When the start point moves beyond the loop point or the end point, this moves the
loop point or the end point as well.
[ROLL] button
While this button is pressed, you can preview the sound several seconds before the end
point.
Playing back a pattern
You can play back the patterns that you created in DJ mode.
1. Press the [PATTERN SELECT] button.
2. Press pads [1]–[16] to select a pattern to play back.
3. Press the [PATTERN SELECT] button.
4. Press the [PATTERN EDIT] button.
The [PATTERN EDIT] button blinks, and the pattern playing back screen appears.
5. Press pad [13].
This plays back the pattern.
Use the [CTRL 1]–[CTRL 3] knobs and press pads [1]–[16] to mix the sound, as with the samples.