15
RootWave Pro User Guide
• The Safety Earth must be fully inserted into the ground for
RootWave Pro to function correctly. Only treat in pots and
troughs if the Safety Earth can be inserted into the ground (not
into the soil in the pot or trough).
• The cables and connectors are not designed to support heavy
loads. Excess loads can damage the connectors. Cables should be
loose, tension free and rest on the ground. Do not allow cables to
span ditches, banks or gaps in the ground as this leads to excess
tension.
• Poor fitment of cable interconnections could result in water
ingress into the connectors and electric shock. Ensure locking
levers are clamped closed before placing cable on the ground.
Check connectors for signs of ingress before and after use.
Remove any debris with a cloth or synthetic brush. Check the
terrain prior to operation and ensure cable connections are kept
away from water and mud.
• Contact between cables and a live treatment electrode or arcs
can cause damage and lead to electric shock. Keep cables tidy
and clear of the treatment zone. Check cables for damage while
cleaning after use. If damage is present then contact your
RootWave Pro supplier.
• Excessive twisting or tension on the cables can damage
connectors and cables or cause excessive cable heating. Always
install Treatment Return without cables connected and
disconnect cables before unscrewing Treatment Return Body
from Treatment Return Blade. Ensure all cables are unravelled
and not left coiled or twisted.
• The Power Module is designed to be installed on a flat horizontal
surface. Do not fix in any other orientation as this may result in
damage to components, electric shock and physical injury.
To Next Page
Loading...