RootWave Pro PRO-001-3 - Table 3 Treatment Lance Features; Table 4 Reset Light

29
RootWave Pro User Guide
Table 3 Treatment Lance features
1
Reset light
and button
The light indicates three different states of the
system
 See Table 4
Press this button to reset the Treatment Lance.
2
Voltage
selector
switch
To select the required voltage level.
 See Table 5
3,
4
Two yellow
triggers
Used in combination to activate the Treatment
Lance, and together or individually to
deactivate the Treatment Lance and activate
Safe Stop.
 See Table 7
5
Live
electrode
warning
light
Lights up in red when the electrode is activated
to indicate the electrode is at a hazardous
voltage.
 See ‘Live electrode warning light’ on page 41
Reset button and light
The Reset light indicates one of the following states:
Table 4 Reset light
Off
The Power Module is not ‘Ready’, cables are not
connected, or there is a fault in the system.
Red flash
Flashes in red when a reset is required either before
first use or after safe stop has been activated.
Green
Lights up when ready to activate and when
activating.