30
RootWave Pro User Guide
• If the reset light is off, this may also indicate that the
generator has tripped.
To reset the Treatment Lance after it has been put into Safe Stop
mode, fully release both triggers and press and hold the reset button
until the flashing red light turns off.
Voltage selector switch
Use the power selector switch to select one the following three
settings:
Table 5 Voltage switch settings
You can use different voltage levels and treatment times depending
on the types of weed being treated and ground conditions. When
treating a weed, its stem diameter and height determines the
voltage setting and treatment duration that you should use.
Table 6 Example voltage settings and treatment duration
Weed height before
trimming
Typical treatment
duration
To Next Page
Loading...