RootWave Pro PRO-001-3 - Figure 5 Electrode Module (Standard Straight Electrode Shown); Electrode Module ETD-001-3

33
RootWave Pro User Guide
Electrode Module ETD-001-3 (also applies to ETD-002-3, ETD-
003-3,ETD-004-3 and ETD-005-3)
The Electrode Module is a changeable component that securely
attaches the electrode to the Treatment Lance, allows alternative
electrode formats to be easily attached, and can be easily replaced if
showing significant signs of wear.
The Electrode Module should be cleaned after use with an alcohol
wipe to prevent the build-up of carbon on the body and around the
electrode which can otherwise lead to accelerated wear.
 See section ‘Setting up the Treatment Lance’ on page 36 for
installation of Electrode Module.
 See section ‘Shrouded Electrode Module’ on page 43 for
information on use of this module.
 Contact your RootWave Pro supplier for alternative electrode
formats including ‘hook’ ETD-002-3, ‘T bar’ ETD-003-3, ‘Arrow’
ETD-004-3, ETD-005-3 ‘Shrouded Electrode Module’ and
replacement Electrode Modules if yours is showing signs of wear.
Figure 5 Electrode Module (standard ‘straight’ electrode shown)