Rotax 125 MAX DD2 evo - Page 108

BRP-Rotax
Operators Manual
Figure 4.4: Ground wire
Variant 2: Additional cable on starter relay
A:
See Cable on starter relay.
The additional cable is NOT attached to the ground wire. The control of the exhaust valve
timing is activated at 9100 rpm.
NOTE
Isolate the additional cable with an electrical/insulating tape to the ground wire so
that a possible contact with the engine ground does not affect the function.
B:
See Cable on starter relay.
The additional cable is attached to the ground wire. The control of the exhaust valve timing
is activated at 8800 rpm.
Effectivity: 125 MAX DD2 evo
4
Page 7
Edition: September 01 2019