BRP-Rotax
INSTALLATION MANUAL
FITTING OF THE SPARK PLUG
The engine will be supplied with a spark plug.
Tools required:
• Feeler gauge
• Socket 21 mm
• Torque wrench
Step
Procedure
1 Remove the transport plug from the
cylinder head.
2
Check electrode gap of spark plug. Ad-
just as required.
NOTE
Check technical regulations to assure conform-
ity when setting the electrode gap.
Step
Procedure
3 Fit supplied spark plug (pos. 1) and
tighten 25 Nm (221 lbf in) to 27 Nm
(239 lbf in).
4
Install the spark plug connector (pos.
2), ensure correct engagement.
Figure 7.2
1
Spark plug
2
Spark plug connector
Effectivity: 125 MAX DD2 evo
6
Page 3
Edition: September 01 2019
To Next Page
Loading...
