BRP-Rotax
Operators Manual
PRESERVATION AND TRANSPORT
PRESERVATION OF ENGINE AND EQUIPMENT
For longer periods out of operation (winter time), make sure that the engine will be properly
preserved.
Step
Procedure
1 Detach carburetor, drain fuel from carburetor and close carburetor openings
to ensure that no dust or dirt can enter.
2
If the vehicle gets stored at temperatures below freezing, drain the entire
cooling system and clean the cooling circuit with pressure air.
m WARNING
Not following this may lead to engine damage.
Step
Procedure
3
Close intake and exhaust port of engine with adhesive tape so that they are
airtight.
4 Apply oil on exhaust system to prevent corrosion.
5
Remove battery from the fixture and charge periodically with the specified
battery charger.
______________________________________________________
TRANSPORT OF THE KART
If the carburetor is still filled with fuel, the kart is only allowed to be transported in a horizontal
position.
If the kart is to be transported in a vertical position, the fuel must be drained from the carburetor
first.
NOTE
If the kart is in a vertical position at transport, the remaining fuel in the carburetor
might flow into the crankcase with the result that the engine won’t start at next try.
Step
Procedure
1
Remove drain screw on float chamber of carburetor and collect the fuel in a
suitable container.
2 Clean drain screw and refit.
______________________________________________________
5
Page 2
Edition: September 01 2019
Effectivity: 125 MAX DD2 evo
To Next Page
Loading...
