2015-2017 5.0L Mustang Phase 1/2 RHD ROUSHcharger Kit
SECTION E – FINAL ASSEMBLY
1316-RHD-AA 12152016 79 800.59.ROUSH
15. If performing the PCM Flash procedure,
proceed to the “PCM Flashing” section. If
the PCM was sent to ROUSH for the Optional
ROUSH Performed Flash and it has been
reinstalled, start the engine and check for
unusual noise, dash service lights, and/or unusual
operation. If problems are detected, immediately
stop the engine or vehicle, diagnose and repair
the problem.
PCM FLASHING
1. If equipped with a SAE J2534 pass through
device, refer to the RDT-CALIM manual found
on our website. The RDT-CALIM manual will
guide you through the ROUSH Diagnostic Tool
(RDT) software installation process and the
ROUSH PCM ashing procedure. OPERATING
THE ENGINE WITHOUT THE RECALIBRATED
PCM WILL RESULT IN ENGINE DAMAGE OR
FAILURE AND WILL VOID THE WARRANTY.
NOTE: Make sure to skip the ICM ash step as
detailed in RDT-CALIM.
2. Once the PCM has been successfully re-
calibrated, start the engine and check for
unusual noises, dash service lights, and unusual
operation. If problems are detected, immediately
stop the engine or vehicle, diagnose and repair
the problem.
To Previous Page
Loading...