2015-2017 5.0L Mustang Phase 1/2 RHD ROUSHcharger Kit
SECTION A – DISASSEMBLY
1316-RHD-AA 12152016 8 800.59.ROUSH
SECTION A – DISASSEMBLY
The following section will guide you through the
disassembly of the stock components. Special care
should be taken to label fasteners and parts that are
taken off during this procedure since many will be
reused:
1. Cover both fenders with fender covers to protect
the vehicle nish.
2. Release the fuel system pressure.
NOTE: The following procedure is taken directly from
the Ford Service Manual.
Fuel in the fuel system remains under high
pressure even when the engine is not running.
Before working on or disconnecting any of the fuel
lines or fuel system components, the fuel system
pressure must be relieved. Failure to do so can
result in personal injury.
Do not smoke or carry lighted tobacco or open
fl ame of any type when working on or near any
fuel-related components. Highly fl ammable
mixtures are always present and can be ignited,
resulting in personal injury.
a. Open the vehicle doors and lift the bottom
cushion of the back seat. It is held in place by
a push tab in the center of each cushion.
b. Disconnect the fuel pump control module
electrical connector located under the driver
side back seat.
c. Start the engine and allow it to idle until it
stalls.
d. After the engine stalls, crank the engine for
approximately 10 seconds to make sure the
fuel injector supply manifold pressure has
been released.
e. Turn the ignition switch to the OFF position.
3. Open the hood. Remove the pushpins from the
battery cover panel located on the passenger side
of the engine bay, and remove the panel.
4. Loosen the retaining nuts and disconnect the
(-) negative and (+) positive connections to the
battery. Stow the cables out of the way.
To Next Page
Loading...