EasyManua.ls Logo

Sabo 52-S A - Emergency Stop, Drive, and Mowing Operations; Emergency Stopping and Drive Operation; Mowing on Slopes and Safety Checks; Time Restrictions

Sabo 52-S A
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
11
GB
Pos: 9. 5 /In nent eil /Abs tel len des M otor s/1 ANH ALT EN IM N OTF ALL @ 5\mod_1183556328817_1521.doc @ 36114
11 EMERGENCY STOPPING
Pos: 9. 6 /In nent eil /Abs tel len des M otor s/An hal ten i m N ot fall H in wei s J S63, Benzi n @ 3\mod_1158833587385_1521.doc @ 20403
ATTENTION
Avoid injury! Engine and blade must stop within 3 seconds. If not, please contact the nearest authorized dealer.
Pos: 9. 7 /In nent eil /Abs tel len des M otor s/An hal ten i m N ot fall T e xt o. A. Benzi n @ 5\mod_1183556795103_1521.doc @ 36166
Release the safety control lever.
The blade will stop.
The engine will stop.
Pos: 10 .1 /---------- 1 Le erzei le ---------- @ 0\ mod_1114611787140_1521.doc @ 2070
Pos: 10 .2 /I nne nt eil/F ahr antr ieb /1 F AHR ANT RI EB @ 0\mod_1115215262046_1521.doc @ 1759
12 MOVEMENT DRIVE
Pos: 10.3 /Inn ent eil/Fa hrantr ieb/1 .1 Bedi enung des Hinterradantriebes (Abbildung G ) @ 0\mod_1115216300453_1521.doc @ 1760
Operating the rear wheel drive (Illustration G )
Pos: 10 .4 /I nne nt eil/F ahr antr ieb /B edien ung des Hi nter ra dantr ieb es T ext @ 0 \mod_1115216328921_1521.doc @ 1762
The rear wheel drive is switched on and off using the drive switch bar (1) on the upper handle (2) when the engine is running:
Press drive switch bar and hold = mower runs.
Release drive switch bar = mower stops (0 position).
Pos: 11 .1 /---------- 1 Le erzei le ---------- @ 0\ mod_1114611787140_1521.doc @ 2070
Pos: 11 .2 /I nne nt eil/M ähb etri eb /1 M ÄHB ETR IEB @ 0 \mod_1115358011109_1521. doc @ 1769
13 MOWING
Pos: 11.3 /Inn ent eil/Sic herh eitshi nwei se/Sic herhei tshi nwei s: Lese n, Mess er, Stei n, Abst and, M otorSt op @ 0\mod_1115358236734_1521.doc @ 1531
Safety instruction!
See table for explanation of symbols page 3
Pos: 11 .4 /I nne nt eil/M ähb etri eb /1.1 hen an H ang lag en @ 0\mod_1115358422453_1521.doc @ 1771
Mowing on slopes
Pos: 11 .5 /I nne nt eil/M ähb etri eb /Mä hen an H angl ag en Si cher hei tshi n weis 25 ° Be nzin @ 19\mod_1346310623849_1521.doc @ 152461
NOTE
The mower can be driven on banks and slopes at an angle of up to 25°. Any steeper slopes can lead to engine
damage.
For safety reasons, however, we urgently recommend you not to exploit this theoretical performance potential.
Always make sure you have a firm stance. Manually guided lawnmowers should never be used for slopes of more
than 15°. Stability may be lost!
Pos : 11.6 /Innenteil/Mähbetrieb/1.1 Ölstandkontroll e @ 0\mod_1115358654859_1521.doc @ 1772
Checking the oil level
Pos: 11 .7 /I nne nt eil/M ähb etri eb /Ölst and ko ntr olle M äh er T ext @ 0\ mod_1115358693671_1521.doc @ 1779
Check oil level each time prior to mowing Y1 . Never let the engine to run with too little or too much oil. Irreparable damages
could occur.
Pos: 11 .8 /I nne nt eil/M ähb etri eb /1.1 Prü fung der B etri ebssi c her heit @ 0 \mod_1115358766390_1521.doc @ 1773
Checking operating safety
Pos: 11.9 /Inn ent eil/Mä hbetri eb/Pr üfung der Betr iebssi cher heit T ext Ben zin Seit enaus wurf @ 21 \mod_1350980143129_1521.doc @ 159831
Before every mowing job, make sure that the safety control bar for the engine brake is working perfectly. When the control
bar is released, the engine and cutter bar must come to a standstill within three seconds. If this is not the case, please
consult your nearest authorised workshop.
Make sure that all protective devices have been attached properly and are not damaged.
To avoid risk, check the condition and firm attachment of the blade before every mowing job. The blade attachment screw
must always be tightened by an authorised workshop. If the blade screw is too tight or too loose, the blade coupling and
cutter bar can become damaged or loose which can lead to serious injuries. A worn or damaged blade must always be
replaced. (refer here to the chapter "Cutter blade care").
In addition, check blade coupling every 10 operating hours for wear and a tight fit. Also check screws and nuts for a firm fit
and tighten if necessary!
Make sure the spark plug connector is fitted tightly. Contact is only dangerous if the plug connector has not been installed
correctly. Never pull the plug connector off with the engine running! Danger: electric shock.
If the mower mechanism becomes blocked e.g. by colliding with an obstacle, have an authorised workshop check whether
any parts of the mower are damaged or deformed. Always have any necessary repairs done by an authorised workshop too.
Pos: 11 .10 / Inn ent eil/M äh betr ie b/1. 1 Z eitli che Ei nsc hrä nkung en @ 0\mod_1115358910000_1521.d oc @ 177 5
Time restrictions
Pos : 11.11 /Innenteil/Mähbetrieb/Zeitliche Einschränkungen T ext @ 0\mod_1115358942500_1521.doc @ 1784
The time at which lawnmowers may be used varies from region to region. Please ask the corresponding authorities before
using your mower.

Table of Contents

Related product manuals