Sam4s ER-350 - Report Samples

ER-350 Electronic Cash Register V2.1 Advanced Programming Instructions • 75
PLU Descriptor
If you are using PLUs, the PLU descriptor print the PLU code unless you choose to program a
custom descriptor. For example, the receipt will look like this:
PLU1 T1 $2.99
PLU23 T1 $1.99
If you wish you can each department descriptor with a custom descriptor, up to 12 characters in
length. For example, you could program your own descriptors like this:
CIGARETTE T1 $2.99
APPLES T1 $1.99
Programming a PLU Descriptor
1. Turn the control lock to the PGM position.
2. Press the @/FOR key.
3. Refer to the “Code Table” on page 76 and enter the two digits that represent each
character you wish. You can enter up to 10 character codes for each PLU.
4. Press the @/FOR key.
5. Enter the PLU number, press the PLU key.
6. Repeat from step 2 for each department you are programming.
7. Press CASH/TEND to end programming.
PLU Descriptor Programming Flowchart
@/
FO
R
Repeat for each PLU
Up to 10
2-digit
character
codes
PLU
PLU
Code
@/
FO
R
CASH/
TEND
PLU Descriptor Programming Example
Program the descriptor for PLU 1 to say “APPLES”
1. Turn the control lock to the PGM position.
2. Press the @/FOR key.
3. Enter the codes representing the text “APPLES”: 2 0 3 5 3 5 3 1 2 4 3 8.
4. Press the @/FOR key.
5. Enter the PLU code, press the PLU key.
6. Press CASH/TEND to end programming.