Sam4s ER-350 - Programming Descriptions; Customer Logo

72 • Advanced Programming Instructions ER-350 Electronic Cash Register V2.1
Programming Descriptions
Customer Logo
Without otherwise programming, the customer logo will print a two line message at the top of each
receipt:
THANK-YOU
CALL AGAIN
If you wish you can replace this message with your own custom message. Your message can be up
to 5 lines long.
Programming a Custom Logo:
1. Turn the control lock to the PGM position.
2. Press the @/FOR key.
3. Refer to the “Code Table” on page 76 and enter the two digits that represent each
character you wish. You can enter up to 26 character codes for each line.
4. Press the @/FOR key.
5. Enter the two digit number that represents the line of the message you wish to program:
11 = 1
st
Line
12 = 2
nd
Line
13 = 3
rd
Line
14 = 4
th
Line
15 = 5
th
Line
6. Press the CHECK TEND key
7. Repeat from step 2 for each line you are programming.
8. Press the CASH/TEND key to end programming.
Logo Programming Flowchart
CHECK/
TEND
CASH/
TEND
Repeat for each Line of the Log
o
Up to 26
2-digit
character
codes
@/
FOR
Line #
Code
@/
FOR