Samson Trovis 6493 - Shipment and On-Site Transport; Accepting the Delivered Goods; Removing the Packaging from the Compact Controller; Transporting the Compact Controller

EB 6493 EN 4-1
Shipment and on-site transport
4 Shipment and on-site trans-
port
The work described in this section is only to
be performed by personnel appropriately
qualied to carry out such tasks.
4.1 Accepting the delivered
goods
After receiving the shipment, proceed as fol-
lows:
1. Compare the shipment received with the
delivery note.
2. Check the shipment for transportation
damage. Report any damage to
SAMSON and the forwarding agent (re-
fer to delivery note).
4.2 Removing the packaging
from the compact controller
Do not remove the packaging until immedi-
ately before mounting and start-up.
1. Remove the packaging from the compact
controller.
2. Check scope of delivery (see Fig.4-1).
3. Dispose and recycle the packaging in ac-
cordance with the local regulations.
1x TROVIS6493 Compact Controller
including seal for .panel mounting (0430-
1495)
1x Document IP6493
(Important Product Information)
1x Accessory 1400-7411, consisting of
2x Mounting clamp for panel mounting
1x 10-pole screw terminal
1x 14-pole screw terminal
1x Adhesive label kit with units
Fig.4-1: Scope of delivery
4.3 Transporting the compact
controller
Transport instructions
− Protect the compact controller against ex-
ternal inuences (e.g. impact).
− Protect the compact controller against
moisture and dirt.
− Observe transport temperature depend-
ing on the permissible ambient tempera-
ture (see the 'Design and principle of op-
eration' section).
4.4 Storing the compact
controller
Risk of damage to the compact controller
due to improper storage.
Î Observe the storage instructions.
Î Avoid long storage times.
Î Contact SAMSON in case of different
storage conditions.
Note
NOTICE
!