Samson Trovis 6493 - Switching over to Manual Mode and Changing the Manipulated Variable; AUX Menu, -CO- ST.IN: Reset to Default Settings

EB 6493 EN 9-3
Operation
9.3 Switching over to manual mode and changing the manipu-
lated variable
Î Switch to manual mode.
The
icon and the manipulated variable Y are shown on the display.
Î Raise the set point.
Î Lower the set point.
Return to automatic mode.
Î Change to automatic mode.
The hand icon is no longer displayed. The current set point is shown.
Press
key to read the manipulated variable Y.
9.4 AUXmenu,-CO-ST.IN:Resettodefaultsettings
Î See Conguration Manual uKH6493.
The Resettodefaultsettings function in the AUX menu causes all parameters, functions and
calibration data to be reset. After the reset, the message FrEE INIT appears on the display.
-CO- ST.IN Reset to default settings
FrEE INIT
OFF
AII INIT All functions, parameters and code number
FUnC INIT All functions
PArA INIT All parameters and code number
AdJ INIT Calibration values for IN1, IN2, Y
Note