Samson Trovis 6493 - Set Point [SETP]; Controller [CNTR]; Output [OUT]; Limit Relays [ALRM]

EB 6493 EN 8-9
Start-up and conguration with TROVIS-VIEW
8.2.3.3 Set point [SETP]
The Set point [SETP] folder corresponds to the SETP main group of the controller. The set
points, set point switchover and set point ramps are set in this folder. In addition, it is possi-
ble to assign an input signal to the position feedback of an actuator or to the feedforward
control.
8.2.3.4 Controller [CNTR]
The Controller [CNTR] folder corresponds to the CNTR main group of the controller. The dy-
namic behavior of the control output and the associated functions are set in this folder. This
includes the direction of action of the calculated control signal, the error and the feedforward
control added to the controlled variable.
8.2.3.5 Output [OUT]
The Output [OUT] folder corresponds to the OUT main group of the controller. The control-
ler's output functions are set in this folder. It is possible to determine whether the controller is
to work with a continuous-action or a switching output. Additionally, the conguration for
on/off and three-step output is performed in this folder.
8.2.3.6 Limit relays [ALRM]
The Limit relays [ALRM] folder corresponds to the ALRM main group of the controller. The
functions of the limit relays L1 and L2 are set in this folder.
8.2.3.7 Additional functions [AUX]
The Additional functions [AUX] folder corresponds to the AUX main group of the controller.
The following functions are determined in this folder:
− Restart conditions after power failure
− Default settings
− Lock control keys
− Viewing angle of display
− Power line frequency
− Number of decimal places for variables directly relating to the analog inputs