Samson Trovis 6493 - Page 38

7-2 EB 6493 EN
Start-up and conguration at the device
Operation in the conguration level
Î See Annex A (conguration guide).
The settings of the controller in the conguration level are shown in the form of schematic di-
agrams:
1
Open conguration level
2
Enter menu
3
Select function/parameter
4
Show setting
5
Activate editing mode for setting/value
6
Change setting/value
7
Conrm setting/value
8
Open parameter level
1)
After opening the conguration level, you are prompted to enter the key number before you edit the
rst function/parameter. If you want to work without a key number, press the enter key again to con-
tinue with the editing mode. Editing is enabled until you exit the conguration level.