Changing Your Settings 258
Android Beam
This feature (when activated via NFC) allows you to directly
beam application content to another NFC-capable device
when they are in direct contact. These files are typically
small such as Calendar and Contact entries.
1. Press ➔ and then tap
Settings
➔
More...
2. Verify the NFC feature is active.
3. Tap
Android Beam
and make sure the feature is turned
on.
4. If not already active, in a single motion touch and slide
the
Android Beam
slider to the right to turn it on
.
5. Complete the transfer process between the two
NFC-enabled devices by placing them back to back.
Wi-Fi Direct Setup and Settings
You can configure your device to connect directly with other
Wi-Fi capable devices. This is an easy way to transfer data
between devices. These devices must be enabled for Wi-Fi
direct communication. This connection is direct and not via a
HotSpot or WAP.
Note:
Activating this feature will disconnect your current Wi-Fi
network connection.
To give your Wi-Fi Direct connection a unique name:
It can be difficult to pair to external devices if all you have is
a generic name (ex: Android 12345). It is recommended you
provide your connection with a unique name.
1. Press ➔ and then tap
Settings
➔
More...
➔
Wi-Fi Direct
.
2. Press and then tap
Device name
.
3. Edit the current name and tap
OK
to save the new
identification.
To Next Page
Loading...
