Samsung SCX-8030ND Series - Page 320

7.Trouble
s
● Code :
C1-1411
● Error message
:
Toner cartridge is n
o
● Symptom / Cause :
The data of CRUM is not detected.
1. Toner cartridge is not placed in the set.
2. Physical obstacle is jamming the electronic signal t
h
3. The signal from set is not proper.
● Troubleshooting method :
Of
1.
O
pen the
f
ront cover.
Remove the waste toner container.
2. Is the toner cartridge placed in the set or not?
YES! NO! → Place the toner cartridge in the set
↓
Pull out the imaging unit and check the modular ja
Pull
out
the
imaging
unit
and
check
the
modular
ja
Is there any contaminations or obstacles?
YES! NO! → Is the modular jack fixed in proper
p
↓ YES! NO! → Replace the toner car
t
↓ ↓
↓ Check whether the electronic signal i
s
↓
Sweep the contaminations or remove the obstacle
s
Install the toner cartridge and do the reverse of No
Is there the error message?
YES! NO! → It’s done.
↓
Check whether the electronic signal is proper or n
o
● Replacement part
-
JC92
-
02302A : PBA
-
ENGINE (SCX
-
8030ND)
JC92
02302A
:
PBA
ENGINE
(SCX
8030ND)
- JC92-02221A : PBA-ENGINE (SCX-8040ND)
Service Manual
SCX-8030/8040 series
7-
2
s
hooting
:
o
t installed. Install the cartridge.
h
rough the modular jack.
.
ack.
ack.
p
osition?
t
ridge with new one.
s
proper or not.
s
.
.1.
o
t. Check the connector and engine board.
SAMSUNG ELECTRONICS
Version 0.05
2
7