Samwon Tech TEMP880S - 4.3.6 WSD Command

SAMWONTECH
1st Edition of TEMP880S IM : Sep. 21. 2005 Page 85 / 101
4.3.6 WSD Command
▶ WSD Command is used in case or using the series data of D-Register.
▶ Format of Reception
The number
of Byte
1 2 3 1 2 1 4 1 4 1 …
S
T
Contents
X
Addr WSD , Number , D-Reg. No1 , dddd-1 , …
1 4 1 4 2 1 1
C L
, dddd-(n-1) , dddd-(n) SUM
R F
▶ Response
The number
of Byte
1 2 3 1 2 2 1 1
S
T
Contents
X
Addr WSD , OK SUM
C
R
L
F
- The number of (~) : 1~32
- dddd F : Data without a point of decimal number (16 number D)
ex) In case of using defrost SP(D0100) and defrost time(D0111)
- Reception : [stx]0101WSD,02,0110,0001,0002[cr][lf]
- Reception (including Check Sum) : [stx] 01WSD,02,0110,0001,0002A6[cr][lf]