SAMWONTECH
1st Edition of TEMP880S IM : Sep. 21. 2005 Page 94 / 101
4.4.4 Set up the Pattern of Program
4.4.4.1 PROGRAM
▶ PROGRAM group is consist of D-Register for making Program Pattern with Communication.
▶ PROGRAM pattern should be set up at TEMP880S by changing the segment number one by one.
▶ D-Register related to PROGRAM Pattern
D-Reg. Signs
Setting
Value
Contents
D1000 P_PTNO 1~120 Set up the No. of Program Pattern when reading or writing
D1001 DEST_PTNO 1~120
Set up the No. of Program Pattern which will be copied
when copying the Pattern
1 INIT : Initializing the contents of D1000~D1004 to '0'
2
READ : Reading with the contents which is set up at D1000
& D1002
3
WRITE : Writing with the contents which is set up at D1000
& D1002
4
PT COPY : Copying the pattern set up at D1000 to the pattern
of D1001
D1003 TRIGGER
5 PT DEL : Deleting the pattern which is set up at D1000
0
FULL : Exceeding of the limited number of pattern or segment
at TEMP880S
1 DONE : Order of D1003(TRIGGER) is managed normally
2 PT EMPTY : No contents set up at a pertinent pattern
4 SEG EMPTY : Not contents set up at a pertinent segment
5 PT RUN : TEMP880S is in PROG RUN condition
D1004 ANSWER
6 PARA ERROR : Setting Error of D1000~D1003
D1010 HTEMP_TSP - PT USED : a pertinent pattern is the condition of PROG RUN
D1011 NTEMP_TSP - Normal temperature room TSP to read or write
D1012 LTEMP_TSP - Low temperature room TSP to read or write
D1013 HTEMP_TIME - High temperature room setting time to read or write
D1014 NTEMP_TIME - Normal temperature room to read or write
D1015 LTEMP_TIME - Low temperature room to read or write
D1016 HTEMP_WSP - High temperature room preheating SP to read or write
D1018 LTEMP_WSP - Low temperature room precooling SP to read or write
D1019 HTEMP_TS1 - High temperature room time signal 1 to read or write
D1020 HTEMP_TS2 - High temperature room time signal 2 to read or write
D1021 HTEMP_TS3 - High temperature room time signal 3 to read or write
D1022 NTEMP_TS1 - Normal temperature room time signal 1 to read or write
D1023 NTEMP_TS2 - Normal temperature room time signal 2 to read or write
D1024 NTEMP_TS3 - Normal temperature room time signal 3 to read or write
D1025 LTEMP_TS1 - Low temperature room time signal 1 to read or write
D1026 LTEMP_TS2 - Low temperature room time signal 2 to read or write
D1027 LTEMP_TS3 - Low temperature room time signal 3 to read or write
D1030 PATTERN_TYPE - Program pattern type to read or write
D1031 CYCLE - Program pattern repetition frequency to read or write
D1032 END_MODE - Operation mode when closing program pattern to read or write
To Next Page
Loading...