Santec MPM-210 - Installation; 4-1 Warning and Caution; 4-2 Environment

Multi-Port Optical Power Meter MPM-210
4-1
Installation
4
・
Dangerous voltages, capable of causing injury or death, are present in this
instrument. Use extreme caution whenever the instrument covers are removed. Do
not remove the covers while the unit is plugged into a live outlet.
・
To avoid electric shock, the power cord protective ground conductor must be
connected to ground.
・
No user serviceable part exists in this instrument. Refer all services to qualified
personnel.
・
Before using this instrument, be sure to read through operation manual and data
sheets to ensure correct operations. Contact SANTEC to obtain service support
and do not install substitute parts or perform any unauthorized modications to this
instrument.
Clearance of 5 cm at the rear side of the unit should be allowed for proper ventilation.
Don't remove rubber feet to ensure air intake.
The mainframe of the MPM-210 weighs about 6.0 kg. Please ensure that the table or
shelf upon which it is installed has sufcient strength.
4-1 Warning and Caution
4-2 Environment
4-3 Line Voltage Selection
Pay attention to the following guidelines for safe, trouble-free operation.
This product is a high-precision device:
・
Do not place in direct sunlight.
・
Do not place under high temperature and high humidity.
・
Do not place in an environment with dust, dirt, salt, or corrosive gas.
・
Do not place in an area subject to large vibrations.
・
Do not place in an area subject to noise by electric eld, magnetic eld, etc.
・
Do not place in an area where the unit is subject to falling objects landing on it.
・
Do not place with possible exposure to water.
・
Do not place with an area of altitude 2000m or more.
This Instrument operates from any single-phase AC power source that supplies
100~240V at a frequency at 50/60Hz. The power consumption is 50VA max.