Sanyo PLC-WL2500 - Page 51

51
Setting
Standby mode
Thisfunctionisavailablewhenoperatingtheprojectorvia
network.
Network.... Supplythepowertothenetworkfunctioneven
afterturningofftheprojector.Youcanturnon/
offtheprojectorvianetwork,modifynetwork
environment,andreceiveane-mailabout
projectorstatuswhiletheprojectorispowered
off.
Eco............SelectEcowhenyoudonotusetheprojector
vianetwork.Theprojector’snetworkfunction
willstopwhenturningofftheprojector.
Refertotheowner’smanualof“NetworkSet-upand
Operation”.
Note:
•FactorydefaultisNetwork.
• WhenEcoisselectedandtheprojectorisinStand-by,
thecommunicationofRS-232Cserialportisnot
available.
TimerleftbeforeLampisoff.
Power management
Forreducingpowerconsumptionaswellasmaintaining
thelamplife,thePowermanagementfunctionturnsoffthe
projectionlampwhentheprojectorisnotoperatedfora
certainperiod.
Selectoneofthefollowingoptions:
Ready.................. Whenthelamphasbeenfullycooled
down,thePOWERindicatorchanges
togreenblinking.Inthiscondition,the
projectionlampwillbeturnedonifthe
inputsignalisreconnectedoranybutton
ontheremotecontrolispressed.
Shut down.......... Whenthelamphasbeenfullycooled
down,thepowerwillbeturnedoff.
Off....................... Powermanagementfunctionisoff.
Timer................... Iftheinputsignalisinterruptedand
nobuttonispressedformorethan
30seconds,thetimerdisplaywithNo
signalappears.Itstartsthecountdown
untilthelampisturnedoff.UsethePoint
▲▼buttonstosettheTimer(1~30Min).
Note:
FactorydefaultisReady: 5 Min.
Power management