Sanyo PLC-WL2500 - Page 52

52
Direct on
WhenthisfunctionissettoOn,theprojectorwillbeautomatically
turnedonjustbyconnectingtheACpowercordtoawalloutlet.
Note:
Besuretoturnofftheprojectorproperly(see“TurningOff
theProjector”onpage20).Iftheprojectoristurnedoffin
theincorrectsequence,theDirectonfunctiondoesnotwork
properly.
Setting
ThisfunctionallowsyoutochangethepresentationoftheP-timer
andexecuteit.
Selectoneofthefollowingoptions:
Count up............. TheP-timerdisplay000:00appearsonthe
screenandthecountstarts(000:00-180:00)
Count down......... ThetimesetintheTimersettingappearsonthe
screenandthecountdownstarts.
Timer.................... UsethePoint▲▼buttonstosettheTimer
(1-180 Min).OnlysettoCount down,Timeris
active.Factorydefaultvalueis10 Min.
Start..................... Itexecutes thecountuporcountdown
function.PresstheSELECTbuttonatStart
andtheindicationchangesintoStop.Tostop
Count uporCount down,presstheSELECT
buttonatStop onthescreenmenu,thenthe
indicationchangesintoRestart.
Reset................... ResettheP-timervalues.
PresstheSELECTbuttonatResettoreturnto
thefollowingvalue;
Count up..."000:00"
Count down...Timerthatyouset
Exit....................... ToexittheP-timeroperation.
Stop or Cancel the P-timer via Remote Control
TostoptheP-timer,presstheP-TIMERbutton.
TocanceltheP-timer,pressandholdtheP-TIMERbuttonforafew
seconds.
P-timer
P-timer