Sanyo PLC-WL2500 - Page 54

54
Remote control
This projector provides two different remote control codes:
thefactory-setinitialcode(Code 1)andthesecondarycode
(Code 2).This switching function prevents remote control
interference when operating several projectors or video
equipmentatthesametime.
WhenoperatingtheprojectorinCode 2,boththeprojector
andtheremotecontrolmustbeswitchedtoCode 2.
To change the code for the projector:
SelecteitherCode 1orCode 2inthisSettingMenu.
To change the code for the remote control:
PressandholdboththeMENUandIMAGEbuttons
togetherfor5secondsormore.Afterchangingthecode,
makesuretheremotecontroloperatesproperly.
Note:
•Whendifferentcodesaresetontheprojectorandonthe
remotecontrol,anyoperationcannotbemade.In that
case,switchthecodeontheremotecontroltofitthecode
ontheprojector.
•Ifthebatteriesareremovedfromtheremotecontrolfora
longperiodoftime,theremotecontrolcodewillbereset.
Thisfunctionallowsyoutochangebrightnessofthescreen.
Normal...... Normalbrightness.
Eco ........... Lowerbrightnessreducesthelamppower
consumptionandextendsthelamplife.
Setting
Lamp control
Remote control