Sanyo PLC-WXE45 - Connecting the AC Power Cord

CAUTION
TheACoutletmustbenearthisequipmentandmustbeeasily
accessible.
Connectin� the AC Power Cord
ConnecttheACpowercord(supplied)tothe
projector.
17
Note:
UnplugtheACpowercordwhentheprojectorisnotin
use.Whentheprojectorisconnectedtoanoutletwiththe
ACpowercord,itisinstand-bymodeandconsumesa
littleelectricpower.
Installation
Thisprojectorusesnominalinputvoltagesof100–120V
or200–240VACanditautomaticallyselectsthecorrect
inputvoltage.Itisdesignedtoworkwithsingle-phasepower
systemshavingagroundedneutralconductor.Toreduce
theriskofelectricalshock,donotplugintoanyothertypeof
powersystem.
Ifyouarenotsureofthetypeofpowerbeingsupplied,
consultyourauthorizeddealerorservicestation.
Connecttheprojectorwithallperipheralequipmentbefore
turningiton.
Topowercord
connectoronyour
projector.
Projector side AC outlet side
Ground
TotheACoutlet.
(120 V AC)
For Continental EuropeFor the U.S.A. and Canada For the U.K.
TotheACoutlet.
(200–240 V AC)
TotheACoutlet.
(200–240 V AC)
NOTE ON THE POWER CORD
ACpowercordmustmeettherequirementsofthecountrywhereyouusetheprojector.
ConfirmtheACplugtypewiththechartbelowandproperACpowercordmustbeused.
IfthesuppliedACpowercorddoesnotmatchyourACoutlet,contactyoursalesdealer.