EasyManua.ls Logo

Sanyo PLC-WXE45 - Cleaning the Air Filters; Resetting The Filter Counter

Sanyo PLC-WXE45
71 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
55
Turnofftheprojector,andunplugtheACpowercord
fromtheACoutlet.
Turnovertheprojectorandremovetheairfiltersby
pullingthelatchesupward.
1
2
Airfilterspreventdustfromaccumulatingonthesurfaceoftheopticalelementsinsidetheprojector.Shouldthe
airfiltersbecomecloggedwithdustparticles,theywillreducecoolingfans’effectivenessandmayresultina
buildupofinternalheatandadverselyaffectthelifeoftheprojector.Cleantheairfiltersbyfollowingthesteps
below.
Cleantheairfilterswithabrushorrinsethemsoftly.
Whenrinsingtheairfilters,drythemwell.
3
Replacetheairfiltersproperly.Makesurethattheair
filtersarefullyinserted.
4
CAUTION
Donotoperatetheprojectorwiththeairfilters
removed.Dustmayaccumulateontheoptical
elementsdegradingpicturequality.Donotput
anythingintotheairintakevents.Otherwiseitmay
resultinmalfunctionoftheprojector.
RECOMMENDATION
We recommend avoidin� dusty/smoky environments
when you operate the projector. Usa�e in these
environments may cause poor ima�e quality.
Whenyouusetheprojectorunderdustyorsmoky
conditions,dustmayaccumulateonthelens,LCDpanels,
oropticalelementsinsidetheprojectordegradingthe
qualityofaprojectedimage.
Whenthesymptomsabovearenoticed,contactyour
authorizeddealerorservicestationforpropercleaning.
Note:
When reinserting the air filters, be sure that
the slit part is facing the outer side.
Cleanin� the Air Filters
Maintenance and Cleanin�
BesuretoresettheFiltercounteraftercleaningorreplacingthefilters.
Press the MENU button to display the On-Screen
Menu. Use the Point ◄► buttons to move the red
framepointertotheSettingMenuicon.
Use the Point buttons to move the red frame
pointer to Filter counter and then press the SELECT
button. A dialog box appears showing the total
accumulated time of the filter use, a timer setting
option, and the reset option. Select Reset and the
Filter counter Reset? appears. Select [Yes] to
continue.
1
2
Resettin� the Filter Counter
Filter counter
Another confirmation dialog box appears, select [Yes]
toresettheFiltercounter.
3
Airfilters
Pullupandremove.
SelectResetand
the“Filtercounter
Reset?”appears.
Select[Yes],
thenanother
confirmation
boxappears.
Select[Yes]again
toresettheFilter
counter.

Table of Contents

Related product manuals