Sanyo PLC-WXE45 - Video Input; Input Source Selection (Video, S-Video)

SelectVideobypressingtheVIDEObuttonontheremote
control.
BeforeusingVIDEObutton,selectthecorrectinputsource
throughmenuoperationasdescribedbelow.
UsetheMENUbuttontodisplaytheOn-ScreenMenu.
PressthePoint◄►buttonstomovetheredframe
pointertotheInputMenuicon.
UsethePoint▲▼buttonstomovetheredarrow
pointertoVideoandthenpresstheSELECTbuttonto
displaytheSourceSelectMenu.
1
2
VIDEO
Movethepointertothe
desiredsourceandpress
theSELECTbutton.
Source Select Menu (VIDEO)
Input Menu
Movethepointertothedesiredsourceandthenpress
theSELECTbutton.
3
Whenselecting“Auto,”theprojector
automaticallydetectstheincomingvideosignal,
andadjustsitselftooptimizeitsperformance.
Theprojectorselectsconnectioninthefollowing
order:
1.S-video
2.Video
Auto
Whenthevideoinputsignalisconnectedtothe
VIDEOjack,selectVideo.
Video
Whenthevideoinputsignalisconnectedtothe
S-VIDEOjack,selectS-video.
S-video
Input Source Selection (Video, S-video)
Direct Operation
Menu Operation
InputMenuicon
Remote Control
VIDEO button
Note:
• Computer 2 is not displayed when the COMPUTER IN
2/MONITOR OUT terminal is set as Monitor out (p.44).
•When the Input Search function is set On1 or On2, the
input signal will be searched automatically (p.44).
34
Video Input
MovethepointertoVideoand
presstheSELECTbutton.
Video