Sanyo PLC-WXE45 - Indicators and Projector Condition

64
Indicators
Projector Condition
POWER
red/�reen
WARNING
red
LAMP
REPLACE
yellow
Theprojectorisoff.(TheACpowercordisunplugged.)
The projector is preparing for stand-by or the projection lamp is
beingcooleddown.Theprojectorcannotbeturnedonuntilcoolingis
completed.
TheprojectorisreadytobeturnedonwiththePOWERON/STAND-BY
button.
Theprojectorisoperatingnormally.
TheprojectorisinthePowermanagementmode.
Thetemperatureinsidetheprojectorisabnormallyhigh.Theprojector
cannotbeturnedon.Whentheprojectoriscooleddownenoughand
the temperature returns to normal, the POWER indicator lights red
and the projector can be turned on. (The WARNING indicator keeps
blinking.)Checkandcleantheairfilters.
The projector has been cooled down enough and the temperature
returns to normal. When turning on the projector, the WARNING
indicatorstopsblinking.Checkandcleantheairfilters.
Theprojectordetectsanabnormalconditionandcannotbeturnedon.
UnplugtheACpowercordandplugitagaintoturnontheprojector.If
theprojectoristurnedoffagain,unplugtheACpowercordandcontact
thedealerortheservicecenterforserviceandcheckup.Donotleave
theprojectoron.Itmaycauseanelectricshockorafirehazard.
Checktheindicatorsforprojectorcondition.
•••green.
•••red •••off
•••blinksgreen.

Whentheprojectionlampreachestheendofitslife,theLAMPREPLACEindicatorlightsyellow.
Whenthisindicatorlightsyellow,replacetheprojectionlampwithanewonepromptly.Resetthelamp
replacementcounterafterreplacingthelamp.Seepages57-58.
Indicators and Projector Condition
•••blinksred.







Appendix