27
Press the ON/STAND-BY button on the side control
or the STAND-BY button on the remote control, and
“Power off?” appears on the screen.
Press the ON/STAND-BY button on the side control or
the STAND-BY button on the remote control again to
turn off the projector. The LAMP/SHUTTER indicator
lights bright and the POWER indicator turns off. After
the projector is turned off, the cooling fans operate for
90 seconds. You cannot turn on the projector during this
cooling down period.
1
2
TO MAINTAIN THE LIFE OF THE LAMP, ONCE YOU
TURN THE PROJECTOR ON, WAIT AT LEAST FIVE
MINUTES BEFORE TURNING IT OFF.
DO NOT UNPLUG THE AC POWER CORD WHILE
COOLING FANS ARE RUNNING OR BEFORE THE
POWER INDICATOR LIGHTS GREEN AGAIN.
OTHERWISE IT WILL RESULT IN SHORTENING OF
THE LAMP LIFE.
3
When the projector has cooled down enough, the
POWER indicator lights green and then you can turn on
the projector. To unplug the AC power cord, wait until
the projector is completely cooled down.
“Power off?” disappears after 4 seconds.
✔Note:
•WhentheOnstartfunctionissetto“On,”theprojectorwillbe
turnedonautomaticallybyconnectingtheACpowercordtoanAC
outlet(p.56).
•Therunningspeedofcoolingfansischangedaccordingtothe
temperatureinsidetheprojector.
•Donotputtheprojectorinacasebeforetheprojectoriscooled
enough.
•IftheWARNINGTEMP.indicatorblinksred,see“Warning
Indicators”onpage68.
•Theprojectorcannotbeturnedonduringthecoolingperiodwith
thePOWERindicatorturnedoff.Youcanturnitonagainafterthe
POWERindicatorbecomesgreenagain.
Turning Off the Projector
DO NOT OPERATE THE PROJECTOR CONTINUOUSLY
WITHOUT REST. CONTINUOUS USE MAY RESULT
IN SHORTENING THE LAMP LIFE. TURN OFF THE
PROJECTOR AND LET STAND FOR ABOUT AN HOUR
IN EVERY 24 HOURS.
Basic Operation
To Next Page
Loading...
Need help?
General
Weight and Dimensions
