Sanyo PLC-XU305A - Laser Pointer Function; Pointer Function

12
Part Names and Functions
Spotlight
Pointer Function
Pointer
Laser Pointer Function
LASERbutton
PRESENTATIONPOINTER
button
This remote control emits a laserbeam from thelaser light window.Press the LASER buttonto activate the
laserpointer.Thesignalemissionindicatorlightsredandtheredlaserbeamisemitted.IftheLASERbuttonis
pressedformorethanoneminuteorifitisreleased,thelaserlightgoesoff.
ThelaseremittedisaClassIIlaser.Donotlookintothelaserlightwindoworpointthelaserbeamatyourselfor
otherpeople.Thefollowingisthecautionlabelforthelaserbeam.
CAUTION: Useofcontrols,adjustmentsorperformanceofproceduresotherthanthosespecifiedhereinmay
resultinhazardousradiationexposure.Neverlookdirectlyintothelaserlightwindowwhilealaser
isemitted,otherwiseeyedamagemayresult.
Thecautionlabelisputontheremotecontrol.
YoucanmovetheSpotlightorPointeroftheprojectorwiththeremotecontroltoemphasizeapartofthe
projectedimage.
Press and hold the MENU and NO SHOW buttons for
more than 5 seconds to activate the Pointer function.
(TheLaserpointerhasswitchedtothePointerfunction.)
1
PresstheLASERbuttonontheremotecontrolpointing
toward the projector. The Spotlight or Pointer is
displayedonthescreenwiththeLASERbuttonlighting
green. Then move the Spotlight or Pointer with the
PRESENTATIONPOINTERbutton.IftheLASERbutton
doesnotlightgreenandcontinuestoemitalaserbeam,
try the abovementioned procedure until the LASER
buttonlightsgreen.
2
To clear the Spotlight or Pointer out the screen, press
theLASERbuttonpointingtowardtheprojectorandsee
iftheLASERbuttonlightingisturnedoff.
ToswitchtotheLaserpointeragain,pressandholdthe
NOSHOWandMENUbuttonsformorethan5seconds
orslidetheRESET/ON/ALL-OFFswitchtoRESETand
thentoON.
WhenyouresetthePointerfunction,theremotecontrol
codewillbereset,aswell.
3
Note:
 You can choose the size of Spotlight (Large/Middle/
Small) and the pattern of Pointer (Arrow/Finger/Dot) in
theSettingMenu.See“Pointer”onpage52.
After the Laser pointer has
switchedto the Pointer, use
the LASER button as the
Pointer function ON-OFF
switch. Press the LASER
button pointing toward the
projector and see if it lights
green.
LaserLightWindow
SignalEmissionIndicator
MENUbutton
NOSHOWbutton
Press and hold the MENU
and NO SHOW buttons for
morethan5seconds.
PRESENTATIONPOINTER
button