Sanyo PLC-XU305A - Rear Terminal

9
Part Names and Functions
Rear Terminal
⑦ S-VIDEO IN
 ConnecttheS-VIDEOoutputsignalfromvideo
equipmenttothisjack(p.17).
⑩ AUDIO IN
 Connecttheaudiooutputsignalfromvideo
equipmentconnectedto
⑦or⑪tothisjack.Fora
monoaudiosignal(asingleaudiojack),connectit
totheL(MONO)jack(p.17).
⑨ COMPUTER 1 / COMPUTER 2 AUDIO IN
 Connecttheaudiooutput(stereo)fromacomputer
orvideoequipmentconnectedto
②or④tothis
jack(pp16,18).
⑪ VIDEO IN
 Connectthecompositevideooutputsignaltothis
jack(p.17).
② COMPUTER IN 1 / COMPONENT IN
 Connectoutputsignalfromacomputer,RGBscart
21-pinvideooutputorcomponentvideooutputto
thisterminal(pp.16,18).
⑧ AUDIO OUT (VARIABLE)
 Connectanexternalaudioamplifiertothisjack
(pp.16-18).
 ThisterminaloutputssoundfromAUDIOIN
terminal(⑨or⑩).
③ MONITOR OUT
 Thisterminalcanbeusedtooutputtheincoming
analogRGBsignalfromCOMPUTERIN2/DVI-I
terminalorCOMPUTERIN1/COMPONENTIN
terminaltotheothermonitor(p.16).
⑤ LAN Connection Terminal
 ConnecttheLANcable(refertotheowner’smanual
“NetworkSet-upandOperation”).
⑫ USB Connector (Series B)
 Inordertooperatethecomputerwiththeremote
controlandusethePAGE
▲▼buttonsonthe
remotecontrolduringapresentation,connectthe
USBportofthecomputertotheUSBterminalwith
aUSBcable(notsupplied)(p.16).
⑥ USB Connector (Series A)
 ConnecttheUSBcable(refertotheowner’smanual
“NetworkSet-upandOperation”).
② ③① ④ ⑤
⑥⑩ ⑦⑨
① CONTROL PORT
 Whentheprojectoriscontrolledbyacomputer,
connecttothisjackwithserialcontrolcable.
④ COMPUTER IN 2 / DVI-I
 Connectcomputeroutput(Digital/AnalogDVI-Itype)
tothisterminal(p.16).
⑧⑪⑫