Sanyo PLC-XU305A - Appendix; Troubleshooting Guide

66
Problem: –Solutions
 –PlugthepowercordoftheprojectorintotheACoutlet.
  –SeeifthePOWERindicatorlightsred.
  –WaituntilthePOWERindicatorstopsblinkingtoturnontheprojector
again.TheprojectorcanbeturnedonafterthePOWERindicator
turnsred.Seepage20.
  –ChecktheWARNINGindicator.IftheWARNINGindicatorlightsred,
projectorcannotbeturnedon.Seepage61.
  –Checktheprojectionlamp.Seepage64.

  –UnlocktheKeylockfunctionfortheprojector.Seepage56.
–MakesureOff orCountdown offarenotchosenatdisplay 
function.Seepage48.
–MakesureUserorOffarenotchosenatLogo(select)
function.Seepage49.
–MakesureInputsearchfunctionisadjustedproperly.Seepage47.
–ThatistheFilterwarningicon.Seepage58.
–ThatistheLampreplacementiconortheFilterwarningicon.See
pages58,64.
 –Adjustfocusoftheprojector.Seepage25.
  –Provideproperdistancebetweentheprojectorandtheprojection
   screen.Seepage15.
  –Checktheprojectionlenstoseeifitneedscleaning.Seepage63.
  –Movingtheprojectorfromacooltowarmplacemayresultin 
   moisturecondensationontheprojectionlens.Insuchcases,leave
   theprojectoroffandwaituntilcondensationevaporates.
 –ChecktheCeiling/Rearfunction.Seepage52.
 –ChecktheCeilingfunction.Seepage52.

–CheckiftheContrastorBrightness areadjustedproperly.See
   pages36,43.
  –Checkif Image modeisselectedproperly.Seepages35,42.
  –Checkthelampcontrolfunction.Seepages27,55.
  –ChecktheLAMPREPLACEindicator.Ifitlights,theendoflamplife
   isapproaching.Replacethelampwithanewonepromptly.Seepage
   64.
Appendix
Troubleshooting
Beforecallingyourdealerorservicecenterforassistance,checktheitemsbelowonceagain.
–Makesureyouhaveproperlyconnectedtheprojectortoperipheralequipmentasdescribedonpages16-18.
–MakesureallequipmentisconnectedtoACoutletandthepoweristurnedon.
–Whentheprojectordoesnotprojectanimagefromtheconnectedcomputer,restartthecomputer.
No power
The initial display is not shown.
The initial display is not same
as the default set.
Input signal switches automatically.
(or does not switch automatically)
When the projector is on and
youpress the input button, an icon
other than the Lamp mode icon
appears.
An icon other than Input mode or
Lamp mode icon appears.
Image is out of focus.
Image is Left/Right reversed.
Image is Top/Bottom reversed.
Picture is not bright enough.
Appendix