Sanyo PLC-XU305A - Page 67

67
Appendix
 –Checktheconnectionbetweenyourcomputerorvideoequipment
   andtheprojector.Seepages16-18.
  –Seeiftheinputsignaliscorrectlyoutputfromyourcomputer.Some
   laptopcomputersmayneedtochangethesettingformonitoroutput
  whenconnectingtoaprojector.Seeyourcomputer’sinstruction
   manualforthesetting.
  –Ittakesabout30secondstodisplayanimageafterturningonthe
   projector.Seepage20.
  –ChecktheInputsignal,colorsystem,videosystemorcomputer
systemmode.
  –MakesurethetemperatureisnotoutofthespecifiedOperating
   Temperature(41˚F–95˚F[5˚C–35˚C]).
  –WhenNoShowfunctionisoperating,theimagecannotbedisplayed.
PresstheNOSHOWbuttonoranyotherbuttonontheremotecontrol.
 –Checktheaudiocableconnectionfromaudioinputsource.
  –Adjusttheaudiosource.
  –PresstheVolume+button.Seepage26.
  –PresstheMutebutton.Seepage26.
 –WhentheAUDIOOUTisplugged-in,theprojector'sbuilt-inspeaker
   isnotavailable.      
  –Istheimageprojected?Youwillhearthesoundonlywhentheimage
 isprojected.
 –ChecktheInputsignal,colorsystem,videosystemorcomputer
   systemmode.      
  –MakesureBlackboardisnotselectedonImageselect 
   menu.Seepages35,42.
 –ChecktheDisplayfunction.Seepage48.

 
  –ChecktheInputsignal.AutoPCadj.functioncannotworkwhen
 480p,575p.720p,480i,575i,1035ior1080iisselectedorwhenthe
   digitalsignalisinputintoDVIterminal.Seepage32.
  –MakesureyouselectedStoreafteradjustingsetting.Somesettings
   cannotbestoredifnotregisteredwithStore.Seepage37,44.
  –PowermanagementfunctioncannotworkwhileFreezeorNo
Showfunctionisrunning.Seepage53.
  –Checktheconnectionandtheinputsignaltoseeifthereissignal.
  –MakesureOffisnotselectedatanyfunctionof"Autosetup".
Seepage47.
–MakesureOnisnotselectedattheCeilingfunction.Seepage52.
 –MakesuretheAutokeystonefunctionisnotsetto
Manual.Press
  theAUTOSETUPbuttononthetopcontrol.Seepages25,47. 

No image
No sound
The color is strange.
Some displays are not seen during
the operation.
Auto PC adjustment function does
not work.
The setting does not remain after
turning off power.
Power management does not work.
Capture function does not work.
Auto setup does not work properly.
Auto keystone function does not
work even when the projector is
tipped.