Sanyo PLC-XU305A - Input Source Management

29
Choose either Computer 1 or Computer 2 by pressing the INPUT button on the top control or press the
COMPUTERbuttonontheremotecontrol.
Before using these buttons, correct input source should be selected through Menu operation as described
below.
1
Input Menu
2
3
Input Source Selection (RGB: Computer 1/Computer 2(Analog))
Computer Input
Wired 1
RGB
RGB(PC digital)
COMPUTER button
Note:
 •Network is for the Network function.  See owner’s
manual“NetworkSet-upandOperation”.
 •WhentheInputSearchfunctionissettoOn1orOn2in
theAutosetupfunction,theinputsignalwillbesearched
automatically(p.47).
Wired 1
RGB
RGB(PC digital)
Computer
1
Top Control
INPUT button
Remote Control
Direct Operation
Menu Operation
PresstheMENUbuttontodisplaytheOn-Screen
Menu.UsethePoint▲▼buttonstoselectInputand
thenpressthePoint►orSELECTbutton.
UsethePoint▲▼buttonstoselecteitherComputer 1
orComputer 2andthenpressthePoint►orSELECT
buttontoaccessthesubmenuitems.
WhenComputer 1isselected,usethePoint▲▼
buttonstoselectRGBandthenpresstheSELECT
button.
WhenComputer 2 isselected,usethePoint▲▼
buttonstoselectRGB(Analog)andthenpressthe
SELECTbutton.
Computer 1
Video
Computer 2
S-video
Computer 1
Computer 2
Network