EasyManua.ls Logo

Sanyo PLC-XU305A - Maintenance and Cleaning; Warning Indicators and Troubleshooting

Sanyo PLC-XU305A
81 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
61
Information
TheWARNINGindicatorshowsthestateofthefunctionwhichprotectstheprojector.Checkthestateofthe
WARNINGindicatorandthePOWERindicatortotakepropermaintenance.
WARNING indicator
The projector is shut down and the WARNING
indicator is blinking red.
When the temperature inside the projector reaches a
certainlevel,theprojectorwillbeautomaticallyshutdownto
protecttheinsideoftheprojector.ThePOWERindicatoris
blinkingwhiletheprojectorisbeingcooleddown.Whenthe
projectorhas cooled down enough (toits normaloperating
temperature), it can be turned on again by pressing the
POWERON/STAND-BYbutton.
The projector is shut down and the WARNING
indicator lights red.
When the projector detects an abnormal condition, it is
automaticallyshutdowntoprotecttheinsideoftheprojector
andtheWARNINGindicatorlightsred.Inthiscase,unplug
the AC power cord and reconnect it, and then turn the
projector on once again to verify operation. If the projector
cannotbeturnedonandtheWARNINGindicatorstilllights
red, unplug theAC power cord and contact the service
station.
CAUTION
DONOTLEAVETHEPROJECTORWITHTHE
ACPOWERCORDCONNECTEDUNDERAN
ABNORMALCONDITION.ITMAYRESULTIN
FIREORELECTRICSHOCK.
Maintenance and Cleaning
Top Control
Top Control
Note:
TheWARNINGindicatorcontinuestoblinkevenafterthe
temperatureinsidetheprojectorreturnstonormal.When
theprojectoristurnedonagain,theWARNINGindicator
stopsblinking.
Then check the matters below:
–Didyouprovideappropriatespaceforthe projectortobe
ventilated?Checkthe installingconditionto see iftheair
ventsoftheprojectorarenotblocked.
–HastheprojectorbeeninstallednearanAir-Conditioning/
Heating Duct or Vent? Move the installation of the
projectorawayfromtheductorvent.
–Arethefiltersclean?Cleanthefiltersperiodically.
WARNING emit a
redlight
WARNINGblinkingred

Table of Contents

Other manuals for Sanyo PLC-XU305A

Related product manuals