53
Setting
Power management
TimeleftbeforeLampisoff.
Power management
For reducing power consumption as well as maintaining
thelamplife,thePowermanagementfunctionturnsoffthe
projection lamp when the projector is not operated for a
certainperiod.
Selectoneofthefollowingoptions:
Ready.................. When the lamp has been fully cooled
down, the POWER indicator changes
to green blinking. In this condition, the
projection lamp will be turned on if the
inputsignalisreconnectedoranybutton
on the top control or remote control is
pressed.
Shut down.......... When the lamp has been fully cooled
down,thepowerwillbeturnedoff.
Off....................... Powermanagementfunctionisoff.
Timer................... If the input signal is interrupted and
no button is pressed for more than 30
seconds, the timer display with No
signal appears. It starts the countdown
untilthelampisturnedoff.UsethePoint
▲▼buttonstosettheTimer(1~30min.).
Note:
Factorydefaultis
Ready: 5 min..
To Next Page
Loading...
