Sanyo PLC-XU305A - Computer System Selection

31
Computer Input
PC System Menu
PC System Menu
Computer System Selection
ThisprojectorautomaticallytunestovarioustypesofcomputerswithitsMulti-scansystemandAutoPC
Adjustment.Ifacomputerisselectedasasignalsource,thisprojectorautomaticallydetectsthesignalformat
andtunestoprojectaproperimagewithoutanyadditionalsettings.(Signalformatsprovidedinthisprojectorare
shownonpages73-74)
Oneofthefollowingmessagesmayappearwhen:
The projector cannot recognize the connected
signal conforming to the provided PC Systems.
Auto is displayed on the System Menu box
and the Auto PCAdjustment function works
to display proper images. If the image is not
projected properly, a manual adjustment is
required(pp.33-34).
There is no signal input from the computer.
Check the connection between your computer
and the projector. (See “Troubleshooting” on
page66.)
Auto
-----
The preset system is manually adjusted in the
PC adjust Menu. The adjusted data can be
storedin Mode 1-5(pp.33-34).
Mode 1
PCSystemsprovidedinthisprojectorischosen.
Theprojectorchoosesapropersystemprovided
intheprojectoranddisplaysit.
SVGA 1
*Mode 1andSVGA 1areexamples.
1
2
PCsystemcanalsobeselectedmanually.
Selecting Computer System Manually
ThePCSystemMenu
Selectedsystemis 
displayed.
Systemsinthis
dialogbox
canbeselected.
Customized
Mode
(1–5)setinthe
PCadjustMenu
(pp.33-34).
PresstheMENUbuttontodisplaytheOn-Screen
Menu.UsethePoint▲▼buttonstoselectInputand
thenpressthePoint►orSELECTbutton.
UsethePoint
▲▼buttonstoselectSystemandthen
pressthePoint►orSELECTbutton.
UsethePoint▲▼buttonstoselectthedesiredsystem
andthenpresstheSELECTbutton.
3