Sanyo PLC-XU305A - Auto PC Adjustment

32
Computer Input
AutoPCAdjustmentfunctionisprovidedtoautomaticallyadjustFine sync,Total dots,Horizontal ,Verticalto
conformtoyourcomputer.
UsePoint▲▼buttonstoselectAuto
PC adj.andpresstheSELECTbutton.
Please wait...appearswhiletheAutoPC
adjustmentisinprocess.
PC adjust Menu
Auto PC Adjustment
To store adjustment parameters
TheadjustedparametersfromtheAutoPCAdjustmentcan
bestoredintheprojector.Oncetheparametersarestored,
the setting can be done just by selecting a Mode (1–5) in
the PC System Menu (see page 31). See also "Store" on
page34.
Note:
 •Fine sync,Total dots,HorizontalandVertical
positionofsomecomputerscannotbefullyadjusted
withtheAutoPCAdjustmentfunction.Whentheimage
isnotprovidedproperlywiththisoperation,manual
adjustmentsarerequired(pp.33-34).
 •TheAutoPCAdjustmentcannotbeoperatedwhen480i,
575i, 480p, 575p, 720p,1035ior1080iisselectedinthe
PCSystemMenu(p.31)orwhenthesignaliscoming
fromtheDVI-terminal.
PresstheMENUbuttontodisplaytheOn-Screen
Menu.UsethePoint▲▼buttonstoselectPC adjust
andthenpressthePoint►buttonortheSELECT
button.
1
2
UsethePoint▲▼buttonstoselectAuto PC adj.and
thenpresstheSELECTbutton.
Auto PC adj.
Menu Operation
Computer Input