Sanyo PLC-XU305A - Page 44

44
Video Input
Use the Point ◄► buttons to adjust the gamma value to
obtainabetterbalanceofcontrast(from0to15).
Gamma
PressthePoint◄buttontodecreasethesharpnessofthe
image;pressthePoint►buttontoincreasethesharpness
oftheimage(from0to15).
Sharpness
An interlaced video signal can be displayed in progressive
mode.Selectoneofthefollowingoptions.
 Off.........Disabled.
 L1..........Foranactivepicture.
 L2..........Forastillpicture.
 Film.......Forwatchingafilm.Withthisfunction,the
projectorreproducespicturesfaithfultothe
originalfilmquality.
Progressive
Noise reduction
Noise interference on the screen can be reduced. Select
oneofthefollowingoptionstogetsmootherimages.
 Off.........Disabled.
 L1..........Lowerreduction
 L2..........Higherreduction
Note:
 
Noise reductionandProgressivecannotbeselected
when480p,575p,720p,1035ior1080iisselected
(p.41).
Toresettheadjusteddata,selectReset andpressPoint►
button.AconfirmationboxappearsandthenselectYes.All
adjustmentswillreturntotheirpreviousfigures.
Reset
Store
Tostoretheadjusteddata,selectStoreandpressPoint►
ortheSELECTbutton.UsethePoint▲▼buttonstoselect
onefromImage1to4andpresstheSELECTbutton.
A confirmation box appears and then select Yes. Stored
data can be called up by selecting an Image (1–4) in the
ImageModeSelectiononpage42.
Aconfirmationbox
appearsandthen
selectYes
.
Store Menu