Sanyo PLC-XU305A - Page 51

51
Setting
Enter a Logo PIN code
UsethePoint▲▼buttonstoenteranumber.Pressthe
Point►buttontofixthenumberandmovetheredframe
pointer to the next box. The number changes to . If
youfixedanincorrectnumber,usethePoint◄buttonto
movethepointertothenumberyouwanttocorrect,and
thenenterthecorrectnumber.
Repeatthissteptocompleteenteringafour-digit
number.
Afterenteringthefour-digitnumber,movethepointerto
Set.PresstheSELECTbuttonsothatyoucanstartto
operatetheprojector.
If you entered an incorrect Logo PIN code, Logo PIN
code and the number (    ) will turn red for a
moment.EnterthecorrectLogoPINcodealloveragain.
LogoPINcodecanbechangedtoyourdesiredfour-digit
number. Press the Point ▼ button to select Logo PIN
code change and then press the SELECTbutton. The
NewLogoPINcodeinputdialogboxappears.Setanew
LogoPINcode.
Besureto note thenewLogo PINcodeand keep iton
hand.Ifyoulostthenumber,youcouldnolongerchange
the Logo PIN code setting. For details on PINcode
setting,referto"PINcodelock"onpages56-57.
UsethePoint▲▼buttonstoswitchOn or Off,andthen
presstheSELECTbuttontoclosethedialogbox.
Change the Logo PIN code lock setting
Enter a Logo PIN code
AfteracorrectLogoPINcode
isentered,thefollowingdialog
boxappears.
CAUTION:
WHEN YOU HAVE CHANGED THE LOGO PIN
CODE, WRITE DOWN THE NEW PIN CODE
IN COLUMN OF THE LOGO PIN CODE NO.
MEMO ON PAGE 79, AND KEEP IT SECURELY.
SHOULD THE LOGO PIN CODE BE LOST OR
FORGOTTEN, THE LOGO PIN CODE SETTING
CAN NO LONGER BE CHANGED.
Change the Logo PIN code lock setting
Change the Logo PIN code
Logo PIN code change