117 English
DATE AND TIME SETTING
5 Set the order in which the date is
displayed during playback.
1 Press the arrow button to select
“DISP”.
2 Press the SET button.
h The Set Date Format Screen
appears.
3 Press [n] or [o].
h When [n] is pressed, the dis-
played date order changes as
follows:
h Press [o] to change in the reverse order.
h If “DISP OFF” is selected, the date the image was captured is not
shown during playback.
4 Press the SET button.
6 Select “EXIT”, and press the SET button.
h The date and time setting is completed, and you are returned to the
Option Mode screen.
NOTE
i Under normal conditions, while the battery pack is being replaced, an inter-
nal battery will maintain the date and time settings. However, there is a
small chance the settings may be lost. (The backup will last for about 7
days.) It is recommended to check that the date and time settings are still
correct after replacing the battery pack and before shooting or recording of
any type (follow steps 1 and 2). Also, when the backup memory has failed
and the camera’s clock is not set, the clock alert icon appears.
To correct the date and time settings
i After steps 1 and 2, press [o] on the arrow button to select the line of the
setting that you want to change, and press [m] to select that setting. Then
press [n] or [o] to set the new setting.
CLOCK SET
DISP
YMD
year/month/day month/day/year day/month/year
DISP OFF (no display)
To Next Page
Loading...
