31 English
CHARGING THE BATTERY PACK
About the CHARGE indicator
The CHARGE indicator shows the sta-
tus of the battery pack and the charger.
Please refer to the following table if the
indicator flashes abnormally.
About the internal backup battery
i This camera’s internal battery serves to maintain the date and time set-
tings, as well as the shooting settings. The backup battery will be fully
charged when the batteries are kept in the camera continuously for about 2
days. In the fully charged state, the backup battery will maintain the cam-
era settings for about 7 days.
When not using the camera for a long time, remove the batteries
i A small amount of power is still used even if the digital camera is turned off,
and it is therefore recommended that the batteries be removed from the
camera if it is not going to be used for a long time. Note that when the bat-
teries are removed for a long period, the time and date settings may be
cleared. Before using your camera again, be sure to confirm that the cam-
era settings are correct.
CHARGE indicator
Not lit Not connected properly
i To recharge the battery pack, the power cord of the
charger must be connected to a power outlet, and the
plug at one end inserted in the charger’s power socket
(see page 29).
i The battery pack is not installed, or it is not installed cor-
rectly (see page 29).
Recharging finished
Lit red Recharging
Red
flashing
Problem with the battery pack or battery pack charger
i Immediately remove the battery pack from the charger.
i Do not use an abnormal battery pack. (The usable life of
the battery pack has probably expired.)
CHARGE indicator
To Next Page
Loading...
Need help?
General
