119
Operating the Scale
Preparation
● Turn on the scale: press e
> The Sartorius logo is displayed
● Select the “Time-controlled functions” application in the Setup menu:
press M
FC Models:
§ Select the Application menu: Press the
App soft key
§ Select
Application 2: Press the q soft key and then the O soft key
FCA Models:
● Select the
Application parameters: press the q key 2 x,
then the O soft key
● Select
Application 2 (control functions):
press the q soft key, then the O soft key
● Select
Time-controlled functions: press the Q or q soft key
● Confirm Time-controlled functions: press the O soft key
Time-controlled Function after Beep
functions time interval Lock in readout
o Automatic printout of values
Store value in applicat. 3 memory
Automatic function o On
restart Off
Storage mode o Without stability
After stability
After higher stability
Print then tare On
oOff
o = factory setting
see also the “Application Parameters (Overview)” in the chapter entitled
“Configuring the Scale”
● Save settings and exit the Setup menu: press the oo soft key
Print Net Values without Printout of Time
Select the Setup menu:
FC Models:
Setup: App: Basic settings: Printout configuration: Auto print upon initialization:
Off
FCA Models:
Setup: Printout: Application-defined output: Auto print upon initialization: Off
Additional Functions
In addition to the functions for:
– alphanumeric input,
– taring (not during alphanumeric
input),
– printing,
you can also access the following
functions from this application:
Calibration/Adjustment
● Press the
isoTST soft key
> See “Calibration/Adjustment” for
further instructions
Toggling to Another Application
● Press D
> See the section on the
corresponding application
program for further instructions
Setup (Setting Parameters)
● Press M
> See “Configuring the Scale” for
further instructions
Turning Off the Scale
● Press e
> The scale shuts off
> The display goes blank, then
OFF or Standby is displayed with
backlighting
To Next Page
Loading...
Need help?
General