Sartorius Factory Series User Manual

7
Configuring the Scale: FC
Configuring the Scale:
FC Models
Purpose
You can configure your Factory scale
to meet individual requirements by
entering user data and setting
parameters in the Setup program.
The Setup menu is divided into five
submenus: configurations,
application menu, scale parameters,
scale menu and user data.
You can also configure the display
to show specific information on the
scale (serial no., etc.).
Configuring the Scale for Use in
Legal Metrology
Set the switch as described below to
configure the following functions for
use of the scale in legal metrology:
– Display: Verification scale
interval:
e;
lower limit of the weighing
capacity: Min
– External calibration blocked
– MP8-interface emulation blocked
§ Remove the covering plate from the
back of the scale housing
§ Move Switch 1 in the direction of
the arrow
FC ... BBE/CCE ...:
> Switch up: external calibration
blocked (factory setting on verified
scales)
Switch down: external calibration
accessible
Setting the Language
Features
You can choose from 5 languages for
the information display:
1 German
2 English (factory setting)
3 English with U.S. date/
time format
4 French
5 Italian
6 Spanish
Selecting the Language
§ Enter the corresponding number
§ Press M
§ Exit the Setup menu:
Press the oo soft key
Entering User Data
(Input)
Purpose
To display, input or change user
data. You can block access to these
data by assigning a password.
Features
You can display, input or change the
following user data:
– Workstation number for the scale:
ID (scale ID; 20 characters max.)*
– Weighing series number, to
designate a series or lot: L ID (lot ID;
20 characters max.)*
– Weight set number for
calibration/adjustment: W ID
(weight ID; 14 characters max.)*
To delete user data:
Enter a . (decimal point)
or a space and confirm
To delete the last character
entered: Press c (see the section
on “Basic Settings” in the chapter
entitled “Operating the Scale”)
– Exact calibration weight value for
calibration/adjustment of the
scale, e.g. for adjustment
according to a DKD certificate
(see the section on “Calibration/
Adjustment” in the chapter entitled
“Operating the Scale”)
– Time (hh.mm.ss; hh can be entered
without a preceding zero)
– Date (dd.mm.yy, or mm.dd.yy
when you select “English with US
date/time” as the language)
– Contrast/angle of the display
(enter a number from 0 to 4;
factory setting: 2)
– Password for access to the Setup
menu, which contains the Input,
Application and Scale Menu
functions (8 characters max.)*
– ID name (20 characters max.):
the factory settings for these
names are ID1, ID2, ID3 and ID4*
The ID name(s) is(are) left-justified.
– Three calibration/adjustment
times (hh.mm; hh can be entered
without a preceding zero)
Calibration/adjustment is repeated
every day at the selected time
settings (up to 3 maximum: for
example, at 7:30, 12:00, 18:15)
*: If the last character of user
data is a letter: conclude input by
pressing a
To delete user data:
Enter a . (decimal point)
or a space and confirm
To delete the last character
entered: Press c (see the section
on “Basic Settings” in the chapter
entitled “Operating the Scale”)

Sartorius Factory Series Specifications

General

Brand	Sartorius
Model	Factory Series
Category	Scales
Language	English