53
Configuring the Scale: FCA
Printout Parameters (Overview)
ο factory setting
√ user-defined setting
Setup Application- Stability parameter Without stability
Print- defined ο With stability
output Print on request, then tare ο Off
On
Auto print upon ο Off
initialization All values
(of the application) Only main values
Configured printout See own chapter starting on the next page
FlexPrint ο Off
On
Automatic output Stability parameter ο Without stability
of displayed At stability
value Automatic after
weight change*
Stop auto print Use print key p
ο Not possible
Time-dependent ο 1 display update
auto print 2 display updates
10 display updates
100 display updates
Output to interface Serial communication ο Application-defined output
port (PERIPHERALS) Automatic output of displayed value
Line format For raw data (16 characters)
ο For other apps/
GLP (22 characters)
ISO/GLP/GMP ο Off
printout Only for calibration/adjustment
Always on
Identification Lot ID (L ID): Enter 20 characters max
ID1: ID1
ID2: ID2
ID3: ID3
ID4: ID4
Factory settings: No
only Yes
printout
* = auto print when load change is >10 d and stability is reached: no printout until residual difference in load value is < 5 d
Factory setting
Factory setting
To Next Page
Loading...
