81
Operating the Scale: FC
Additional Functions
In addition to the functions for:
– alphanumeric input,
– taring (not during
alphanumeric input),
– printing (NUM print; S ID),
you can also access the following
functions from this application:
Calibration/Adjustment
§ Press the
isoTST soft key
> See “Calibration/Adjustment”
for further instructions
Toggling to the Next Application
§ Press D
> See the section on the
corresponding application
program for further instructions
Setup (setting parameters)
§ Press M
> See “Configuring the Scale” for
further instructions
Turning Off the Scale
§ Press e
> The scale shuts off
> The display goes blank
Practical Example
Toggle the Display From Grams [g] (1st Unit) to Pounds [lb] (2nd Unit)
Settings (changes in the factory settings required for this example):
Setup: App: Application 1: Toggle wt. units: Weight unit 2: Pounds/lb
Step Key (or instruction) Display/Output
1. Delete previous setting if necessary c
(
U1
: Weight unit 1)
2. Change weight unit lb soft key
to Pounds [lb]
(
U2
: Weight unit 2)
3. Change weight unit g soft key
to Grams [g]
To Next Page
Loading...
Need help?
General