84
Practical Example
Determining an Unknown Piece Count; Weighing in the Preset Reference Sample Quantity
Settings (changes in the factory settings required for this example):
Setup: App(lication parameters): Application 1: Counting: Average piece weight updating: Manual
FCA Models: Setup: Printout: Application-defined output: Autoprint upon initialization: All values
Step Key (or instruction) Display/Output
1. Delete previous setting if necessary c
2. Prepare a container for the Place the empty container
parts to be counted on the scale
3. Tare the scale t
4. Place the reference sample quantity Place the displayed number
on the scale (example: 10 pcs) of parts in the container
5. Determine the average piece
Start soft key
weight (number of decimal
places displayed depends on
the scale model)
6. If necessary, increase the number Place additional parts
of parts and perform reference in the container
sample updating (example: Update soft key
7 additional pieces)
7. Weigh uncounted parts Place parts to be counted
in the container
8. If desired, print total piece count p
(here: 153 pcs)
To Next Page
Loading...
Need help?
General